Hold and standby features allows the actuator to pause operation, wait for a signal before resuming control, or wait a specific time period before resuming control and moving to a defined valve angle. Useful for filling a tank or in sanitry washdown situations.

Using the Auxiliary input port of the Emech G1 Actuator to enable inverse control logic. Inverse control logic reverses the normal control logic, i.e, in normal logic you would close the cold port of a 3 port valve if the temperature is below the setpoint temperature but in inverse control, the cold port is opened further. Useful in the dough mixing process in a bakery where accurate temperatures are required for the water used to mix dough regardless of ambient conditions.

This video shows how to load the standard default configuration to a Emech G1 actuator.

This video shows how to reassemble the seals and discs on an Emech Control F2 two port water mixing valve.

This video shows how to do electrical tests on all keyswitch powered G1 Actuators using a digital multimeter. The tests check the integrity of the power supply and current loop circuits.

This video shows how to do electrical tests on the G1 actuator (revision E and later) using a digital multimeter. The tests check the integrity of the power supply and current loop circuits.

How to mount the Emech control F4 water mixing valve onto the G1 electronic actuator.

This video shows how to change the Emech control G1 actuators properties in Emech config software.

How to configure the Emech G1 actuator to control an F3 water mixing valve.

How to mount the Emech G1 actuator onto an F3 water mixing valve.

How to reassemble the Emech F5 steam water mixing valve and also replace the seals and discs.

How to use the Emech G1 actuators manual override handle to control the opening and closing of an F3 water mixing and F5 steam water valve.

This video shows how to replace the seals and discs on an Emech F3 water mixing valve and also how to reassemble it.

Cycle testing of Emech control water valve and electronic G1 actuator.

Emech Steam Water Heater using Komax TM high volume steam water inductor. As installed at National Beef LLC in 2008. Video taken at Worldwide Food Show October 2007.

Emech actuator mounted onto a chlorine gas butterfly valve.

Emech Control segment on TVNZ Breakfast business television show Wednesday 12 December 2007.

Emech Control F3-050 in operation showing high speed and resolution at the recent World Wide Food Technology Show Chicago.